|
|
STURDY AND DEPENDABLE: PANAVISE
Work Positioning Systems for Today's Technologies
300
STANDARD BASE
Our best seller! The 300 Standard Base holds all regular Pana Vise Heads and Circuit Board Holders. The patented single load control knob and exclusive split-ball feature have a range of tension which permits movement of work to any desired position. This single knob firmly locks the head in place. Loosening the knob reduces the load on the split ball, permitting the head to be removed from the base. This exclusive feature allows use of numerous heads with one base. By acquiring different heads, a versatile holding system is created at a reasonable cost. This base had three mounting holes for permanent attachment directly to a work bench or to various portable Base Mounts. It is 3-3/4" (95mm) high and accepts all 5/8" (16mm) stems.
CAT. #300 PRICE $38.55
400
HEAVY DUTY BASE
The 400 Heavy Duty Base has been designed for heavy weights and pressures. It is 4-1/8" (105mm) square with four 5/16" (8mm) mounting holes. Designed specifically to be used with the 437 Heavy Duty Fixturing Head, it will accept any 1" (25mm) stem or post. An additional feature allows the user to change between a serrated or smooth face on the ball housing for more positive adjustment of the tilt control.
CAT. #400 PRICE $72.50
337
FIXTURING HEAD
The 337 Fixturing Head allows permanent fixturing for production line assembly or repetitive repair. Work can be bolted to this head easily because of its six slots and bolt holes. Wood carvers and pattern makers can easily secure their blanks to this head. The work is held firmly in any position through final finishing. The flat round surface is 5-3/8" (137mm) in diameter. The steel stem is die cast into the aluminum head and is 2" (51mm) long and 5/8" (16mm) in diameter.
CAT. #337 PRICE $34.75
303
STANDARD HEAD
The 303 Standard Head is our top selling head. Jaws are 2-1/2" (64mm) wide and open to 2-1/4" (57mm). The tough, yet gentle, nylon jaws have a satin finish to improve grip. Steel, brass, Teflon, and grooved nylon jaws are available as accessories for all heads. This general purpose head has exceptional quality and strength. The stem is 2-1/8" (54mm) long and 5/8" (16mm) in diameter.
CAT. # 303 PRICE $46.21
437
HEAVY DUTY HEAD FOR THE 400 BASE ONLY
The 437 Heavy Duty Head is only used with the 400 Heavy Duty Base. This rugged head gives you a positioning device for working on heavy parts, lawnmower motors, typewriters, etc. It is extensively used as a heavy camera mount. The head is made of heavy cast aluminum, 3" by 6" (76mm by 152mm) with a 1" (25mm) diameter shaft.
CAT. # 437 PRICE $41.35
311
BENCH CLAMP
BASE MOUNT
The 311 Bench Clamp Base Mount is for the 300 Standard or 305 Low Profile Base. It clamps to the edge of any work bench or table up to 3-1/2" (89mm) thick. Four neoprene pads are included and may be used when additional anti-slip characteristics are desired without excessive tightening of the clamping screw. Using the pads also helps prevent marring of table surfaces. Three screws are included for mounting a base to the bench clamp.
CAT. #311 PRICE $72.10
|